Skip to main navigation Skip to search Skip to main content

UV-Induced Degradation of High-Efficiency Silicon PV Modules with Different Cell Architectures

  • SLAC National Accelerator Laboratory
  • National Renewable Energy Laboratory

Research output: Contribution to journal › Article › peer-review

158 Scopus Citations

Abstract

This paper reports the investigation of UV-induced degradation (UVID) in various types of silicon PV technologies through an accelerated UV testing. Degradation from ultraviolet (UV) radiation has become prevalent in the front of solar cells due to the introduction of UV-transmitting encapsulants in photovoltaic (PV) module construction. Here, we examine UV-induced degradation (UVID) in various commercial, unencapsulated crystalline silicon cell technologies, including bifacial silicon heterojunction (HJ), interdigitated back contact (IBC), passivated emitter and rear contact (PERC), and passivated emitter rear totally diffused (PERT) solar cells. We performed UV exposure tests using UVA-340 fluorescent lamps at 1.24 W m-2 (at 340 nm) and 45 degrees C through 4.02 MJ m-2 (2000 h). Our results showed that modern cell architectures are more vulnerable to UVID, leading to a significant power decrease (-3.6% on average; -11.8% maximum) compared with the conventional aluminum back surface field (Al-BSF) cells (<-1% on average). The power degradation is largely caused by the decrease in short-circuit current and open-circuit voltage. A greater power decrease is observed in bifacial cells with rear-side exposure compared with those with front-side exposure, indicating that the rear side is more susceptible to UV damage. Secondary ion mass spectroscopy (SIMS) confirmed an increase in hydrogen concentration near the Si/passivation interface in HJ and IBC cells after UV exposure; the excess of hydrogen could result in hydrogen-induced degradation and subsequently cause higher recombination losses. Additionally, surface oxidation and hot-carrier damage were identified in PERT cells. Using a spectral-based analysis, we obtained an acceleration factor of 5x between unpackaged cells (containing a silicon nitride antireflective coating on the front) in the UV test and an encapsulated module (with the front glass and encapsulant blocking 90% of the UV at 294 nm and 353 nm, respectively) in outdoor conditions. From the analytical calculations, we show that a UV-blocking encapsulant can reduce UV transmission in the module by an additional factor of ~50.
Original languageAmerican English
Pages (from-to)36-51
Number of pages16
JournalProgress in Photovoltaics: Research and Applications
Volume31
Issue number1
DOIs
StatePublished - 2023

NLR Publication Number

  • NREL/JA-5900-81471

Keywords

  • bifacial heterojunction
  • PV modules
  • UV-induced degradation
  • UVID

Fingerprint

Dive into the research topics of 'UV-Induced Degradation of High-Efficiency Silicon PV Modules with Different Cell Architectures'. Together they form a unique fingerprint.

Cite this